PRODUCT OVERVIEW
The ADN2928 provides the transmit and receive functions of quantization, loss of signal detect, and clock and data recovery at rates from 9.953 Gbps to 11.1 Gbps. The part is designed with the flexibility to allow it to be used in either Telecoms or Datacoms XFP module applications. The key advantages of this circuit’s delay and phase-locked loop architecture are that it provides a low jitter transfer bandwidth of 1 MHz, while also exceeding the jitter tolerance requirements of XFP, SONET, Gigabit Ethernet and Fibre Channel. The architecture also provides fundamentally 0 dB of Jitter peaking.
FEATURES
Fully integrated limiting amplifier and signal conditioner transceiver IC
Meets XFP Telecoms and Datacoms module requirements
Supports OC-192, OC-192-FEC, 10GE, 10GFC, 10GE G.709
Line and system loop-back modes
Integrated Rx limiting amplifier with 10 mV sensitivity
Tx path equalizer for up to 12 inches of FR4
Rx loss of signal (LOS) detector
CML serial data interface
Supply power: 760 mW
3.3 V and 1.8 V power supplies
XFI signalling
Flip-chip, 49-pin BGA, 6 mm . 6 mm package
Temperature range 0°C to 85°C
Power down mode
APPLICATIONS
XFP MSA module receive/transmit signal conditioner
SONET OC-192, (+FEC) transponders
10 gigabit Ethernet optical transceivers
10 gigabit small form factor modules
Test equipment
Serial backplane applications
No comments:
Post a Comment